Hot Melt Granulators - Series HMG-1008

HMG-1008 Hot Melt GranulatorsThe Hot Melt Model is intended for processing hot thermoplastic directly from the extruder die without pre-cooling. Hot blow molding parisons, wire and cable hot melt, as well as compounding applications normally performed by a water stream pelletizer, can all be handled by this machine.

An integrally mounted high CFM direct drive blower both cools the cutting chamber and conveys the granulate produced to a bin, from one extruder to another, as might be required in startup and purging operations. The standard model is equipped with an 8" x 1" inlet horn, but other sizes can be provided optionally, as dictated by the specific applications.

Hot Melt Granulators


  • Rotor: 4 Bladed.
  • Inlet Size: 8" x 1" (others optional).
  • Power: 5 HP (TEFC).
  • Screen Size: 1/4" diameter (standard), others optional.
  • Conveying/Cooling System: 3 HP (TEFC) direct drive blower with Model 500 cyclonic air separator.

*All dimensions are in inches
*Information on this page subject to change without notice.

Contact us today: - Tel: 973.227.0700

We accept the following major credit cards:

high shear granulators


high shear granulators

23 Spielman Road, Fairfield, New Jersey, USA, 07004-6155
Tel: 973.227.0700 ~ Fax: 973.227.7307 ~ Email: